Larkin rescue frame manual assembly instructions

If a cable must be touched or if accidental contact is possible, follow the following instructions: 1) wear insulated gloves and goggles, 2) measure the voltage between the cable and body ground using an electrical tester, and 3) insulate the cable using insulating tape. Wash them immediately with a large amount of water and seek medical care.Дo not touch any bare cables that could be high voltage cables. If the electrolyte comes in contact with your eyes, call out loudly for help. If the electrolyte comes in contact with an article of clothing, take it off immediately. If the electrolyte comes in contact with your skin, use a saturated boric acid solution or a large amount of water to wash it off. Wipe the neutralized liquid with a shop towel or piece of cloth. Wear rubber gloves and goggles, neutralize the liquid with saturated boric acid solution and then apply red litmus paper to the liquid. Precautions to be observed when servicing a damaged vehicleДo not touch any leaked liquid because it could be highly alkaline electrolyte. qts) saturated boric acid solution (obtain 800 g (1.76 lb) of boric acid powder, put it into a container, and dissolve it in water)ДЄ shop towel or piece of cloth (for wiping off the electrolyte) Protective clothing (insulated gloves, rubber gloves, goggles and safety shoes)Дў0 liters (21.1 US qts, 17.6 Imp. Items to be prepared (when repairing a damaged vehicle) Wipe up the neutralized liquid with a shop towel or piece of cloth. Wear rubber gloves and goggles, neutralize the liquid with saturated boric acid solution, and then apply red litmus paper to the liquid. If you see any liquid on the road surface, it could be highly alkaline electrolyte leakage. Remove the service plug grip while wearing insulated gloves.ДЄctions required after moving the damaged vehicle Turn the ignition switch off, and disconnect the cable from the negative (-) auxiliary battery terminal. Perform the procedure below if the hybrid system warning light turns on, or there are abnormal noises, unusual smells, or strong vibrations while driving:ДЄpply the parking brake, and then move the shift lever to P position. Make sure that none of the cloths or tools that were used have been left in the engine compartment or within the vehicle. Make sure that removed and installed parts (oil filler cap, level dipstick, floor mat, etc.) are properly installed/tightened. Retain the removed parts for customer inspection, if requested. Place the removed parts in a separate box to avoid mixing them up with new parts or contaminating the new parts.ДЇor non-reusable parts such as gaskets, O-rings and self-locking nuts, replace them with new ones as instructed in this manual. Temporarily mark hoses and their fittings if needed.Д¬lean and wash the removed parts if necessary and assemble them after a thorough check. Add matchmarks to ensure reassembly of components in the original positions. For example, note the total number of electrical connections, bolts or hoses removed. If the procedure is complicated, take notes.

Removal and installation, disassembly and assembly operationsДiagnose with a thorough understanding of proper procedures and of the reported problem.Д«efore removing any parts, check the general condition of the assembly and for deformation and damage.

Preparation of tools and measuring equipmentД«efore starting work, prepare a tool stand, SST, measuring equipment, oil, and any replacement parts required. When lifting up the vehicle, use appropriate safety equipment. When jacking up the vehicle, be sure to support the specified locations with safety stands. If working on high temperature, high pressure, rotating, moving or vibrating parts, wear appropriate safety equipment and take extra care not to injure yourself or others. When working with the engine running, make sure to provide ventilation for exhaust fumes in the workshop. When working with 2 or more persons, be sure to check the safety of one another. Prepare a grille cover, fender cover, seat cover and floor mat before starting work.

Larkin rescue frame manual assembly instructions